Cabletron Systems MT8-MIM Especificaciones descargar pdf (Pagina 97)

Troubleshooting Guide 9-1

CHAPTER 9

TOKEN RING PROBLEMS

This chapter provides a troubleshooting guide that identiﬁes some of the more common problems related to

Token Ring networks. Refer to the following list of problems and proceed to the appropriate section shown in

parentheses for the possible causes and remedy.

NOTE: In this chapter, references to SPECTRUM Element Manager for Windows (SPEL)

refers to both management applications, SPEL and Remote LANVIEW for Windows.

1. Cannot Use IP Address of the Old Token Ring Management Module (TRMM) to Poll Its Replacement

TRMM — (Section 9.1)

2. Cannot Reinsert Rebooted PCs Into a Properly Operating Ring — (Section 9.2)

3. Cannot Communicate with the Server After a Beaconing Condition on the Network — (Section 9.3)

4. There Is a Constant Stream of Burst Errors on the Network — (Section 9.4)

5. There Is a Constant Stream of Line Errors on the Network — (Section 9.5)

6. LCD on Standalone Management Device (TRXI, Micro-T, or STHI) Indicates an Eagle Insertion Error,

Type 7 — (Section 9.6)

7. Communication Between Two Rings Across a Newly Added TRBMIM Is Not Possible with Internet Packet

Exchange (IPX) Protocol — (Section 9.7)

8. Token Ring Users Cannot Communicate with Their Ethernet Servers in a Novell Environment (IPX) —

(Section 9.8)

9. Non-Cabletron Auto-Sensing Interface Card Cannot Insert Onto the Cabletron Systems Active TRMIM, but

Operates Properly with a Passive Board — (Section 9.9)

10. TRBMIM Goes into Out-of-Standby Condition — (Section 9.10)

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 113 114

Sin comentarios

Cabletron Systems MT8-MIM Especificaciones Pagina 97