Cabletron Systems MT8-MIM Especificaciones descargar pdf (Pagina 94)

Chapter 8: Terminal Server Problems

8-24 Troubleshooting Guide

ABC

A typical port setup in admin for a PPP link without PAP security on port 8 of the CSMIM2 is as follows (use

your own IP address):

admin: set port local_address 128.20.195.30

You may need to reset the appropriate port, Annex subsystem or

reboot the Annex for changes to take effect.

admin: set port remote_address 128.20.195.95

You may need to reset the appropriate port, Annex subsystem or

reboot the Annex for changes to take effect.

admin: set port allow_compression y

You may need to reset the appropriate port, Annex subsystem or

reboot the Annex for changes to take effect.

admin: set port slip_ppp_security n

You may need to reset the appropriate port, Annex subsystem or

reboot the Annex for changes to take effect.

admin: set port ppp_security_protocol none

You may need to reset the appropriate port, Annex subsystem or

reboot the Annex for changes to take effect.

admin: reset 8

admin:

Enter the following command:

show port PPP

The following is an example of the resultant display.

port asy8:

local_address: 128.20.195.30 remote_address: 128.20.195.95

dialup_addresses: N metric: 1

slip_ppp_security: N net_inactivity: 10

phone_number: "" do_compression: N

allow_compression: Y net_inactivity_units: seconds

ppp_mru: 1500 ppp_acm: 0x0

ppp_security_protocol: none ppp_username_remote: ""

ppp_password_remote: "<unset>" ppp_ncp: all

ppp_ipx_network: 00000000

ppp_ipx_node: 00-00-00-00-00-00

Try to dial in as a terminal.

Was the dial-in successful?

YN

Call Cabletron Technical Support.

Congratulations, the problem is solved.

ABC

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 113 114

Comentarios a estos manuales

Sin comentarios