Cabletron Systems MT8-MIM Especificaciones descargar pdf (Pagina 95)

Troubleshooting Guide 8-25

ABC

Set up the CSMIM2 security. Refer to the CSMIM2 Network Administrator Guide, Book A for details.

Go to Section 8.8 and proceed with that troubleshooting procedure.

Enter the username and the password when prompted.

Did security work?

Y N

Go to Section 8.8 and proceed with that troubleshooting procedure.

Enter the command,

ppp.

Did an error message display?

The problem is most likely with the remote host PPP software.

NOTE: Access through security was successful, which means the (PPP) software on the remote host has

to be set up for Password Authorization Protocol (PAP) security.

Refer to the remote host PPP software documentation for help. Call Cabletron Technical Support.

With the CSMIM2 in the Admin Mode, enter the following (for example for port 8):

port 8

show port ppp

The following is an example of the resultant display.

port asy8:

local_address: 0.0.0.0 remote_address: 0.0.0.0

dialup_addresses: N metric: 1

slip_ppp_security: N net_inactivity: 10

phone_number: "" do_compression: N

allow_compression: N net_inactivity_units: seconds

ppp_mru: 1500 ppp_acm: 0x0

ppp_security_protocol: none ppp_username_remote: ""

ppp_password_remote: "<unset>" ppp_ncp: all

ppp_ipx_network: 00000000

ppp_ipx_node: 00-00-00-00-00-00

A typical port setup in admin for a PPP link using PAP security on port 8 of the CSMIM2 is as follows (use your own IP

address):

admin: set port local_address 128.20.195.30

You may need to reset the appropriate port, Annex subsystem or

reboot the Annex for changes to take effect.

admin: set port remote_address 128.20.195.95

You may need to reset the appropriate port, Annex subsystem or

reboot the Annex for changes to take effect.

admin: set port allow_compression y

You may need to reset the appropriate port, Annex subsystem or

reboot the Annex for changes to take effect.

admin: set port slip_ppp_security y

You may need to reset the appropriate port, Annex subsystem or

reboot the Annex for changes to take effect.

(continue)

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 113 114

Comentarios a estos manuales

Sin comentarios

Cabletron Systems MT8-MIM Especificaciones Pagina 95

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Cabletron Systems MT8-MIM