Cabletron Systems MT8-MIM Especificaciones descargar pdf (Pagina 90)

Chapter 8: Terminal Server Problems

8-20 Troubleshooting Guide

ABCD

At the UNIX host, enter the “more eservices” command. A display similar to the following example should

appear. In this example, the last line is commented and charmer is the host name in the host prompt.

charmer 2# more eservices

# erpc remote programs

# prog no. verlo verhi name

1 0 0 bfs

#3 0 99 acp

charmer 3#

Is the last line commented (# precedes the line)?

Enter the

ls -cal command. A list of files are displayed.

Is there an acp_passwd file?

Create an acp_passwd file. Refer to the CSMIM2 Annex Administrative Guide, Book A, the chapter on

security for instructions. Try dialing in again.

Did the username display?

Ping to the IP address of the CSMIM2.

Was the pinging successful?

Go to Section 8.4 and proceed with that troubleshooting procedure.

Call Cabletron Technical Support.

Congratulations, the problem is solved.

Ping to the IP address of the CSMIM2.

Was the pinging successful?

Refer to the problem described in Section 8.4 and proceed with that troubleshooting procedure.

Congratulations, the problem is solved.

With the CSMIM2 in the Administrative Mode, enter

the following at the “admin:” prompt.

show annex security

The following shows an example of the resultant display.

enable_security: N security_broadcast:

pref_secure1_host: 0.0.0.0 pref_secure2_host: 0.0.0.0

network_turnaround: 2 loose_source_route: Y

acp_key: "<unset>" password: "<set>"

allow_snmp_sets: N lock_enable: Y

passwd_limit: 3 chap_auth_name: "chap"

A (continued)

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 113 114

Sin comentarios

Cabletron Systems MT8-MIM Especificaciones Pagina 90