Cabletron Systems MT8-MIM Especificaciones descargar pdf (Pagina 26)

Chapter 3: Booting/Image Code Loading Problems

3-8 Troubleshooting Guide

3.1.4 TFTP Downloading Using a PC with Remote LANVIEW, Version 2.0x

Remote LANVIEW 2.0x uses a proprietary IP stack. If you have a green icon (such as the EMME icon shown

in Figure 3-6) for the device to which you want to TFTP download, no ARP entry is needed. Just pull down the

Control menu and then the TFTP Download menu.

Figure 3-6. Control Pulldown Menu and TFTP Download Window

3.2 BootP Downloading Guidelines When Using a PC

If a device is requesting a BootP download, you still need to set up the ARP Table. However, in this case you

have to get the MAC address from the white label on the device.

A device requests a BootP download because of one of the following reasons:

• BootP was initiated locally at the device using a switch on the device

• TFTP download was interrupted and the original image (system software for the device) could not be

restored

In either case, approximately ﬁve minutes after your Network Management Software (NMS) loses connection

with the device, the icon displayed for that device turns red, indicating that the device was disconnected (no

longer recognized) and its IP to MAC address correlation was dropped from the ARP Table. To correct this

situation, you must conﬁgure the correct MAC address for the interface that your device is connected to.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 113 114

Sin comentarios

Cabletron Systems MT8-MIM Especificaciones Pagina 26