
Chapter 8: Terminal Server Problems
8-26 Troubleshooting Guide
admin: set port ppp_security_protocol pap
You may need to reset the appropriate port, Annex subsystem or
reboot the Annex for changes to take effect.
admin: reset 8
admin:
Enter the following command:
show port PPP
The following is an example of the resultant display.
port asy8:
local_address: 128.20.195.30 remote_address: 128.20.195.95
dialup_addresses: N metric: 1
slip_ppp_security: Y net_inactivity: 10
phone_number: "" do_compression: N
allow_compression: Y net_inactivity_units: seconds
ppp_mru: 1500 ppp_acm: 0x0
ppp_security_protocol: pap ppp_username_remote: ""
ppp_password_remote: "<unset>" ppp_ncp: all
ppp_ipx_network: 00000000
Try dialing in again using your PPP software.
Was the dial in successful?
YN
Call Cabletron Technical Support.
Congratulations, the problem is solved.
Comentarios a estos manuales