Cabletron Systems T2015 Guía de instalación Pagina 284

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 419
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 283
274 Installation Guide for Clients
Western Digital EtherCard Plus and EtherCard Plus/A
Required entry:
drivername = macwd$
The following table summarizes the possible entries and values in the
[macwd] section of the LAN Manager PROTOCOL.INI file:
Entry Units Range Default
drivername macwd$
iobase (EtherCard Plus
only)
hex. 200–3E0 280
irq (EtherCard Plus only) 2–15 3
maxrequests integer 6–24 8
maxtransmits integer 6–24 12
ramaddress (EtherCard
Plus only)
hex. A000–FFFF D000
receivebuffers integer 6–24 12
receivebufsize bytes 256–1536 256
receivechains integer 6–24 12
Entries in the [macwd] section of the LAN Manager PROTOCOL.INI
file have the following meanings:
drivername
Identifies the driver name of the network device driver.
iobase (EtherCard Plus only)
Indicates the base I/O address for the network adapter. This entry
must match the adapter’s I/O address jumper settings.
irq (EtherCard Plus only)
Indicates the interrupt level of the network adapter.
Value Meaning
2–7 EtherCard Plus: interrupt levels 2–7
3, 4, 10, 15 EtherCard Plus/A (16-bit slot only): interrupt levels 3, 4, 10,
and 15
maxrequests
Specifies the number of request-queue entries.
maxtransmits
Specifies the number of transmit-queue entries.
ramaddress (EtherCard Plus only)
Indicates the base address of the shared memory on the adapter.
receivebuffers
Specifies the number of receive-buffer queue entries.
Vista de pagina 283
1 2 ... 279 280 281 282 283 284 285 286 287 288 289 ... 418 419

Comentarios a estos manuales

Sin comentarios