
184 Installation Guide for Clients
Everex SpeedLink/PC16
Required entry:
• drivername = macevx$
The following table summarizes the possible entries and values in the
[macevx] section of the LAN Manager PROTOCOL.INI file:
Entry Units Range Default
drivername — — macevx$
interrupt integer 2–15 2
ioaddress hex. 320–3A0 360
Entries in the [macevx] section of the LAN Manager PROTOCOL.INI
file have the following meanings:
drivername
Identifies the driver name of the network device driver.
interrupt
Indicates the interrupt level of the network adapter. Interrupts 9, 11,
12, and 15 are available only when the adapter is installed in a 16-bit
slot.
ioaddress
Indicates the current I/O address jumper configuration of the network
adapter. The value you select on the adapter must equal this entry’s
value. If this entry does not match the adapter’s switch settings, the
driver reports an error. Possible values are 320, 330, 340, 350, 360,
380, and 3A0.
Comentarios a estos manuales