Cabletron Systems WPIM-DDS Guía de instalación descargar pdf (Pagina 56)

Chapter 4: Troubleshooting

4-10 HSIM-W6 Installation Guide

WPIM-DDS Installed in HSIM-W6

The DDS circuit is Out of Service (OOS).

• Contact your WAN DDS Service Provider and have them test the operation of your DDS circuit.

Status (STS) LED is AMBER (blinking)

• Device is in test mode.

• The CSX400 is running its Power-up Diagnostic Tests.

• Loopback Testing is underway on a WAN circuit.

Status (STS) LED is GREEN

WPIM-SYNC Installed in HSIM-W6

The Port is operating normally; Request to Send (RTS) has been activated by your WAN device. If

it is not, use the following steps:

• Use QuickSET or Local Management to make sure that the WAN interface on the local device

is conﬁgured properly.

• Verify the cabling being used between the HSIM-W6 and the CSU/DSU.

WPIM-HDSL is Installed in HSIM-W6

The Port is operating normally, the WPIM is synchronized with the HDSL circuit at the remote

end.

WPIM-S/T is Installed in HSIM-W6

The Port is operating normally, ISDN BRI channel B1 or B2 or both are active.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 91 92

Sin comentarios

Cabletron Systems WPIM-DDS Guía de instalación Pagina 56