Cabletron Systems WPIM-DDS Guía de instalación Pagina 18

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 92
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 17
Chapter 2: About the HSIM-W6
2-4 HSIM-W6 Installation Guide
Optional Feature
Hardware Data Compression Module (CSX-COMP/ENCR) The same industry standard
STAC Electronics Stacker LZS Compression algorithm supported by HSIM-W6 software is made
available by an optional hardware data compression module that accelerates data compression for
the HSIM-W6 over Nailed-up PPP or ISDN and Frame Relay. Depending on the packet type and
size, hardware data compression provides a minimum of 2:1 data compression, giving 3 Mbps
throughput on each T-1 WPIM interface. To use the hardware data compression module,
compatible equipment (such as the HSIM-W6, CSX200, and CSX400 or other vendors’
equipment which conforms to the applicable standards) must be in use at both ends of the WAN
link. When the hardware data compression module is installed on the board, it automatically
assumes the compression task from software. There is no configuration necessary to prioritize
hardware over software compression.
HSIM-W6 Firmware Support
The HSIM-W6 firmware supports IEEE 802.1d bridging, and IP and IPX routing, and OSI Layer 2
Inverse Multiplexing (IMUX), which allows both WAN channels to be used as a single, high
bandwidth, WAN channel. Wide Area Networking includes Point-to-Point Protocol (PPP), Frame
Relay, and ISDN. Remote access is via Full or Fractional T1, E1, Synchronous, Digital Data
Service, ISDN BRI, or HDSL connections.
This device supports industry-standard protocols, security features, compression algorithms and
network management tools to ensure interoperability with equipment from other vendors.
WAN Protocols
This device supports the following WAN protocols over the WAN port:
Point-to-Point Compression Control Protocol (CCP) as defined by RFC 1962
Point-to-Point Protocol (LCP) as defined by RFC 1661
Point-to-Point Protocol (BNCP) as defined by RFC 1638
Point-to-Point Protocol (IPCP) as defined by RFC 1473
Point-to-Point Protocol (IPXCP) as defined by RFC 1552
Frame Relay as defined by RFC 1490
Frame Relay Data Compression Protocol (DCP) as defined by FRF.9
Vista de pagina 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 91 92

Comentarios a estos manuales

Sin comentarios