Cabletron Systems EPIM F3 Guía de usuario descargar pdf (Pagina 37)

INSTALLATION

3-9

Figure 3-9 EPIM-T Cross-over Switch

To connect a EPIM-T to a Twisted Pair Segment:

1. Connect the twisted pair segment to the module by inserting the RJ-45

connector on the twisted pair segment into the RJ-45 port on the

module. See Figure 3-10.

Figure 3-10 The EPIM-T

2. Check that the LNK LED for the port is lit. If the LED is not lit,

perform each of the following steps until it is:

a. Check that the 10BASE-T device at the other end of the twisted

pair segment is powered up.

b. Verify that the RJ-45 connector on the twisted pair segment has

the proper pin-outs as shown in Figure 3-11.

c. Check the cable for continuity.

EPIM-T

Front Panel

Switch

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 81 82

Sin comentarios

Cabletron Systems EPIM F3 Guía de usuario Pagina 37