Cabletron Systems EPIM F3 Guía de usuario descargar pdf (Pagina 32)

INSTALLATION

3-4

Note: 1/4-inch Molly screw anchors for wall mounting are not included

with the MRXI.

1. Use the supplied screws to attach the wall mounting brackets to the

bottom of the MRXI as shown in Figure 3-4. There are two brackets,

one for each side.

Figure 3-4 Installing the Wall Mounting Brackets

2. Select the wall location for the MRXI within 7 feet of a power outlet.

WARNING: There is a potential SHOCK HAZARD if there is electrical

wiring within the wall that interferes with drilling for pilot holes. Select a

wall location where drilling pilot holes for the Molly screws will not come in

contact with electrical wiring in the wall.

3. You will need a pencil for this step. With the wall mounting brackets

attached to the MRXI, position the MRXI against the wall where it

will be permanently mounted with the network port facing down. Use

the pencil to mark the wall location for the four pilot holes.

4. Set the MRXI aside and carefully drill four 1/4” pilot holes, one for

each of the Molly screw anchors and insert the four Molly screw

anchors into the holes just drilled.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 81 82

Sin comentarios

Cabletron Systems EPIM F3 Guía de usuario Pagina 32