Cabletron Systems MT8-MIM Especificaciones descargar pdf (Pagina 67)

Configuration Views Setting Redundant Circuits

SPECTRUM Enterprise Manager Page67 Cabletron Ethernet Hubs

To set redundant circuits for the devices modeled

in SPECTRUM, follow these steps:

1 Click on the icon to select it.

2 If contact has been established and the icon is

green, bring up the Configuration View.

3 From the Configuration View menu, click on

the Redundancy

RedundancyRedundancy

Redundancy button. In the Redundancy

View window, click on Redundancy Table

Redundancy TableRedundancy Table

Redundancy Table.

4 Choose any circuit from the Circuit Name list

that appears by double-clicking on it. A

Redundancy Information View window

appears.

5 Set the Retry Count to any value between 1

and 10, inclusive.

6 For any of the devices other than the IRM-3

enter the Ethernet address of the secondary

hub device, which will be polled, in the MAC

Address Add field. This field should allow you

to enter the address in any of the following

formats (where X is any hexadecimal value

from 0 to F):

• XX.XX.XX.XX.XX.XX

• XX:XX:XX:XX:XX:XX

• XX-XX-XX-XX-XX-XX

For the IRM-3, enter the IP address of the

secondary hub device, which will be polled, in the

IP Address Add field. You should enter this

address in the format NNN.NNN.NNN.NNN (where

NNN is a decimal number from 0 to 255).

7 Enter the Board Port Instance for the primary

connection. For example, if the primary

connection is on port 4 of a module in the

device’s fifth slot, the Board Port Instance

would be 5.4. (Modules on these devices start

from 1 and can go up to 8 depending on the

MMAC type.)

8 Change the Port Circuit Status to Active

ActiveActive

Active and

the Port Circuit Type to Primary

PrimaryPrimary

Primary.

9 Choose Save All Changes

Save All ChangesSave All Changes

Save All Changes from the File menu.

This will save the circuit configuration you

entered.

10 Now change the Board Port Instance to

represent the backup connection. Change the

Port Circuit Status to Inactive

Inactive Inactive

Inactive and the Port

Circuit Type to Backup

BackupBackup

Backup.

11 Choose Save All Changes

Save All ChangesSave All Changes

Save All Changes from the File menu.

This will save the circuit configuration you

entered for the backup connection.

12 Close this Redundancy Information View and

then bring it up again. Verify that the

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 75 76

Comentarios a estos manuales

Sin comentarios

Cabletron Systems MT8-MIM Especificaciones Pagina 67

Comentarios a estos manuales

Relacionado con productos y manuales para Software Cabletron Systems MT8-MIM