Cabletron Systems MT8-MIM Especificaciones descargar pdf (Pagina 66)

Configuration Views Setting Redundant Circuits

SPECTRUM Enterprise Manager Page66 Cabletron Ethernet Hubs

be used with MRXI and MiniMMAC hubs as

primary devices. The secondary device can be any

hub device with redundancy capability (e.g.,

MRXI, MiniMMAC, IRM2, IRM3). This procedure

may also be used to configure multiple secondary

hub devices.

Note:

These instructions assume that you

have a primary MMAC hub module

port physically attached to a

secondary MMAC hub module port.

Both these modules must have

redundant circuit capability. The

backup port connection cannot be

completed until you have set up the

active connection in SPECTRUM. For

convenience, you should also prepare

a list of secondary hub Ethernet

addresses before beginning this

procedure.

Also, SNMP devices require the use of

the Community Name attribute. The

SPECTRUM default of “public” grants

read-only privileges, which allow you

to view device attributes, but not

modify them. Since setting up

redundancy requires modifying the

device attributes, you should set the

Community Name to “ctron,” which

grants read/write privileges. You can

set the Community Name when you

create the device or change it in the

Device Configuration View.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 75 76

Sin comentarios

Cabletron Systems MT8-MIM Especificaciones Pagina 66