Cabletron Systems RoamAbout Guía de usuario descargar pdf (Pagina 27)

Preparing for the Installation 2-3

Reviewing the Site Preparation Checklist

Electrical and Environmental Requirements

√ Ensure that the electrical and environmental requirements are within the ranges

described in the Product Specifications section in Chapter 1.

Cabling Requirements

√ For standalone and DEChub 90 AP configurations: Ensure that you have two 9-pin

DECconnect adapters (H8571–J) and an MMJ DECconnect BC16E cable for

connecting the setup port device to the AP.

For MultiSwitch 900 configurations: Ensure that you have a 9-pin DECconnect

adapter (H8571–J) and an MMJ DECconnect BN24H cable for connecting the setup

port device to the MultiSwitch 900. If your local setup port device is a PC running

terminal emulation software, you can use a 9-pin, D-Sub (PC-compatible) serial (null

modem) cable.

√

For a standalone configuration, ensure that you have the appropriate types and lengths

of cable for connecting the AP to the wired Ethernet. For a 10BaseT connection, use a

BN26K cable. For a ThinWire connection, you need a BC16M cable, T-connector

(H8223-00), and 50-ohm terminator (H8225-00).

NOTE

Refer to Appendix A for connector, cable and adapter pinout information.

For information on cabling and configuring Ethernet LANs and using

DECconnect system products, refer to the DECconnect System Planning and

Configuration Guide. This guide also provides ordering information.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 89 90

Sin comentarios

Cabletron Systems RoamAbout Guía de usuario Pagina 27