Cabletron Systems RoamAbout Guía de usuario descargar pdf (Pagina 16)

Summary of Access Point Features

1-4 Introducing RoamAbout Access Point

3

Module OK LED

Lights (green) when the module passes its

power-up self-test. If the module fails the

power-up self-test, the Module OK LED is

off. If this LED is flashing, the Ethernet or

wireless port (or both) has a fault, preventing

connection to the network.

4 Wired LAN Activity

LED

Indicates the status of the wired Ethernet

segment. The LED lights (green) when

packets are received on the Ethernet port and

then forwarded to the wireless port or the AP’s

management software. Packets received and

filtered are not shown. The LED also lights

when the AP’s management software

transmits packets on the Ethernet port. The

data traffic forwarded to the Ethernet port is

not shown. The average brightness of the

LED indicates the level of activity on the

Ethernet port. If the LED is flashing together

with the Bridge State LED (6), the Ethernet

port has a fault that prevents the AP from

establishing a connection to the network.

5 10BaseT Ethernet

Connector

Connects the module to a 10BaseT network.

This connector is not used if the AP is

connected to a ThinWire network, or if the

module is installed in a MultiSwitch 900 or

DEChub 90.

6

Bridge State LED

Lights (green) when the AP is forwarding

packets.

7 Access Point Saturated

LED

Lights (yellow) when the AP is saturated.

Saturation occurs when the AP cannot

forward packets from the Ethernet to the

wireless side due to the lower throughput of

the wireless network. The degree of LED

brightness indicates the level of saturation.

The LED dims (and eventually extinguishes)

as the network congestion is processed.

Item Name Description

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 89 90

Comentarios a estos manuales

Sin comentarios