Cabletron Systems RoamAbout Guía de instalación descargar pdf (Pagina 39)

Installing the Access Point 3-3

Wall/Ceiling Outlet Box Installation

3 Remove the mounting bracket from the Access Point:

• Completely loosen the captive screw.

• Slide the bracket until the two screw slots are directly below the two

screws.

• Lift and remove the bracket from the Access Point.

4 Connect the Ethernet cable, or wire the MOD-TAP connector:

Refer to MOD-TAP Connector Wiring on page 2-15.

5 Before installing the metal mounting bracket, make certain that the

mounting holes on the bracket line up with those on the outlet box.

Additional holes may be drilled in the bracket to accommodate your

particular installation.

Remove all drilled material from the area.

Step Action

fig1

Screw Slot (2)

Screw (2)

Remove

Mounting Bracket

Captive Screw

NOTE

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 67 68

Sin comentarios

Cabletron Systems RoamAbout Guía de instalación Pagina 39