Cabletron Systems SmartSwitch Router Especificaciones descargar pdf (Pagina 57)

SmartSwitch Router 2100 Getting Started Guide 41

Chapter 3: Software Installation and Setup

– If a particular command has been applied such that it can be expanded on

additional interfaces/modules, then it is annotated with a “P”. For example, if you

enabled STP on all ports in the current system, however, the SSR contains only one

module, then that particular command could be expanded at a later date when

more modules have been added to the SSR.

A command like stp enable et.*.* would be displayed as follows:

indicating that it is only partially applied. If you add more modules to the SSR at

a later date and then update the configuration file to encompass all of the available

modules in the SSR, then the “P:” portion of the above command line would

disappear when displaying this configuration file.

If a potentially partial command, which was originally configured to encompass

all of the available modules on the SSR, becomes only partially activated (after a

hotswap or some such chassis reconfiguration), then the status of that command

line will automatically change to indicate a partial completion status, complete

with “P:”.

Note:

Commands with no annotation or annotated with a “P:” are not in error.

P: stp enable et.*.*

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 73 74

Sin comentarios

Cabletron Systems SmartSwitch Router Especificaciones Pagina 57