Cabletron Systems SmartSwitch 8000 Guía de usuario descargar pdf (Pagina 6)

vi SmartSwitch 9A100 User Guide

FIBER OPTIC PROTECTIVE CAPS

%"¤›apm READ BEFORE REMOVING FIBER OPTIC PROTECTIVE CAPS.

Cable assemblies and MMF/SMF ports are shipped with protective caps to prevent contamination. To avoid

contamination, replace port caps on all fiber optic devices when not in use.

Cable assemblies and MMF/SMF ports that become contaminated may experience signal loss or difficulty inserting

and removing cable assemblies from MMF/SMF ports.

Contamination can be removed from cable assemblies by

U Blowing surfaces with canned duster (Chemtronics p/n ES1270 or equivalent).

U Using a fiber port cleaning swab (Alcoa Fujikura LTS p/n ACT-01 or equivalent) saturated with

optical-grade isopropyl alcohol, gently wipe the end surface of ferrules first; then wipe down the

sides of both ferrules.

U Blow ferrule surfaces dry with canned duster.

Contamination can be removed from MMF/SMF ports by

U Using the extension tube supplied with canned duster, blow into the optical port, being careful not

to allow the extension tube to touch the bottom of the optical port.

U Reconnect cable and check for proper mating. If problems remain, gently wipe out optical port with

a DRY fiber port cleaning swab and repeat step 1.

%"¤›apm To avoid contamination, replace port caps on all fiber optic devices when not in

use.

1 2 3 4 5 6 7 8 9 10 11 ... 113 114

Sin comentarios

Cabletron Systems SmartSwitch 8000 Guía de usuario Pagina 6