Cabletron Systems SSIM-R8-02 Especificaciones descargar pdf (Pagina 86)

100

101

ATM Sample Configuration 1

66 Enterasys Xpedition User Reference Manual

Configuring an Interface on each Ethernet Port

There are two separate VLANs in this network, VLAN A and VLAN B. VLAN A is

connected to Ethernet port et.2.1 on XP1, and VLAN B is connected to Ethernet port et.1.1

on XP2.

Apply an interface on both Ethernet ports. Creating an interface on an Ethernet port

assigns a network IP address and submask on that port.

Creating a Virtual Channel

Create a VC to connect ATM port at.1.1 on XP1 to ATM port at.2.1 on XP2. Use the

following command to create a virtual channel on XP1 with vpi=0 and vci=100:

You must now configure a corresponding vpi/vci pair on ATM port at.2.1. Use the

following command to create a virtual channel on XP2 with vpi=0 and vci=100:

Note that you are using the same vpi and vci on both XPs. This establishes a common VC

from one ATM port to another ATM port.

Defining an ATM Service Profile

After creating a VC connection from ATM port at.1.1 to at.2.1, the next step is to define an

ATM service profile for this connection.

The following command lines defines a service profile named ‘cbr1m’ on both XP1 and

XP2 where CBR is the service category and peak cell rate is set to 10000 kcells/second:

ssr1(config)# atm create vcl port at.1.1.0.100

ssr2(config)# atm create vcl port at.2.1.0.100

ssr1(config)# atm define service cbr1m srv-cat cbr pcr-kbits 10000

ssr2(config)# atm define service cbr1m srv-cat cbr pcr-kbits 10000

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 393 394

Comentarios a estos manuales

Sin comentarios

Cabletron Systems SSIM-R8-02 Especificaciones Pagina 86

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Cabletron Systems SSIM-R8-02