Cabletron Systems SSIM-R8-02 Especificaciones descargar pdf (Pagina 218)

Configuring Advanced Routing Policies

198 Enterasys Xpedition User Reference Manual

To create route import policies, enter the following command in Configure mode:

The <imp-src-id> is the identifier of the import-source that determines the source of the

imported routes. If no routes from a particular source are to be imported, then no

additional parameters are required.

The <filter-id>, if specified, is the identifier of the route-filter associated with this import-

policy. If there is more than one route-filter for any import-source, then the ip-router

policy import source <imp-src-id> command should be repeated for each <filter-id>.

Creating an Import Source

Import sources specify the routing protocol from which the routes are imported. The

source may be RIP or OSPF.

To create an import source, enter one of the following commands in Configure mode:

Creating a Route Filter

Route policies are defined by specifying a set of filters that will match a certain route by

destination or by destination and mask.

To create route filters, enter the following command in Configure mode:

Create an import policy.

ip-router policy import source <imp-src-id>

[filter

<filter-id>|[network <ipAddr-mask>

[exact|refines|between

<low-high>]

[preference

<number>|restrict]]]

Create a RIP import

destination.

ip-router policy create rip-import-source <name>

Create an OSPF import

destination.

ip-router policy create ospf-import-source <name>

Create a route filter. ip-router policy create filter <name-id> network <IP-

address/mask>

1 2 ... 213 214 215 216 217 218 219 220 221 222 223 ... 393 394

Sin comentarios

Cabletron Systems SSIM-R8-02 Especificaciones Pagina 218