Cabletron Systems HSIM-W6 Guía de instalación descargar pdf (Pagina 34)

Chapter 3: Installation

3-6 HSIM-W84 Installation Guide

12. Reattach the standalone device’s cover to the standalone device and reconnect the power cord.

13. Reconnect the standalone device to your network.

CSX-COMP/ENCR Installation

This section contains instructions on how to install the COMP/ENCR into the HSIM-W84. To help

eliminate any potential problems during or after installation, read and understand the following

steps:

1. Attach one end of the antistatic wrist strap to your wrist and the other end to an approved

electrical ground.

2. Unpack the CSX-COMP/ENCR by carefully removing it from the shipping box and then from

the protective plastic bag. Do not cut the bag as the device could be damaged. If there are any

signs of damage, contact the Cabletron Systems Global Call Center (refer to Chapter 1,

Installation).

3. Install the CSX-COMP/ENCR in the HSIM-W84 by unlocking the top and bottom plastic

locking tabs of the module faceplate. Slide out the module and place it on its side with the

internal components facing up.

4. Locate the D-Type connector and the standoffs on the HSIM-W84 (refer to Figure 3-3).

5. The D-Type connector pins of the CSX-COMP/ENCR only fits one way onto the HSIM-W84

D-Type connector. Lower the CSX-COMP/ENCR onto the standoffs and align the connector

with the connector pins. Carefully insert the connector pins of the CSX-COMP/ENCR into the

connector on the HSIM-W84.

6. Press down firmly on the CSX-COMP/ENCR until the pins fit all the way into the connector.

7. Secure the CSX-COMP/ENCR with the standoff screws supplied with the CSX-COMP/ENCR.

The CSX-COMP/ENCR installation is complete.

NOTE

Ensure that the CSX-COMP/ENCR is aligned such that its connector pins correctly align

with the D-Type connector on the HSIM-W84.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 59 60

Sin comentarios

Cabletron Systems HSIM-W6 Guía de instalación Pagina 34