Cabletron Systems HSIM-W6 Guía de instalación descargar pdf (Pagina 15)

HSIM-W84 Firmware Support

HSIM-W84 Installation Guide 2-3

WAN Protocols

This device supports the following WAN protocols over the WAN port:

• Point-to-Point Compression Control Protocol (CCP) as deﬁned by RFC 1962

• Point-to-Point Protocol (LCP) as deﬁned by RFC 1661

• Point-to-Point Protocol (BNCP) as deﬁned by RFC 1638

• Point-to-Point Protocol (IPCP) as deﬁned by RFC 1473

• Point-to-Point Protocol (IPXCP) as deﬁned by RFC 1552

• Frame Relay as deﬁned by RFC 1490

• Frame Relay Data Compression Protocol (DCP) as deﬁned by FRF.9

• Inverse Multiplexing (IMUX)

• Dynamic Host Conﬁguration Protocol (DHCP) as deﬁned by RFC 1541

• Network Address Translation (NAT) routing as deﬁned by RFC 1631

• Password Authentication Protocol (PAP) and Challenge Handshake Authentication Protocol

(CHAP) under PPP as deﬁned by RFC 1994

• Point-to-Point Protocol Link Quality Monitoring (LQM) as deﬁned by RFC 1333

• Frame Relay Link Management Interface (LMI) as deﬁned by ANSI T1.617 Annex D and ITU

Q.933 Annex A

• Frame Relay Data Encapsulation as deﬁned by RFC 1490

• Frame Relay Data Compression Protocol (DCP) as deﬁned by FRF.9

PPP is a data link layer industry standard WAN protocol for transferring multi-protocol data trafﬁc

over point-to-point connections. With this protocol, options such as security, data compression,

and network protocols can be negotiated over the connection.

Frame Relay is a packet-switching data communications protocol that statistically multiplexes

many data conversations over a single transmission link. Data Compression (DCP) allows Frame

Relay to negotiate compression over Frame Relay permanent virtual circuits (PVCs).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

Sin comentarios

Cabletron Systems HSIM-W6 Guía de instalación Pagina 15