Cabletron Systems Access Server 316 Guía de instalación Pagina 247
- Pagina / 302
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
22-5
Messages 500 – 599
To disconnect the SLIP session, enter the following command. Substitute the session
number for 2.
Local> DISCONNECT SESSION 2
For more information on configuring and managing SLIP ports, refer to the Network
Access Software Management Guide.
Local -561- Starting SLIP or PPP datalink session
Explanation: This message is displayed to the local terminal when the CONNECT
"datalink" command is entered.
Action: No action is required.
Local -562- Invalid SLIP or PPP argument
Explanation: You have attempted to modify a SLIP or PPP characteristic to an incorrect
or out-of-range value.
Action: For more information on the SET/DEFINE/CHANGE SLIP command, refer to
the Network Access Software Commands Reference Guide.
Local -564- Console messages are not output during PPP sessions
Explanation: This message is displayed on the port defined as the access server console
when the PPP enabled command is entered..
Action: No action is required.
Local -565- Max Configures must be between 1 and 15
Explanation: The value for the PORT PPP LCP/IPCP/ATCP/IPXCP MAXCONFIGURE
was out of range.
Action: Configure with a value within the range of 1 and 15.
Local -566- Max Failures must be between 1 and 15
Explanation: The value for the PORT PPP LCP/IPCP/ATCP/IPXCP MAXFAILURE was
out of range.
Action: Configure with a value within the range of 1 and 15.
Local -567- Max Terminate must be between 1 and 15
Explanation: The value for the PORT PPP LCP/IPCP/ATCP/IPXCP MAXTERMINATE
was out of range.
Action: Configure with a value within the range of 1 and 15.
- DECserver 1
- Network Access Software 3
- Problem Solving Guide 3
- Web site: www.dnpg.com 4
- Contents 5
- Chapter 4 SLIP/PPP Problems 6
- Chapter 14 IPX Problems 11
- Chapter 18 Messages 000 – 099 12
- Chapter 26 Messages 900 – 999 14
- Chapter 29 Service Guidelines 14
- Typographical Conventions 16
- Associated Documents 17
- Software WWENG2 MNENG2 WWENG2 20
- Image(s) MNENG3 20
- Verify the Load Host 21
- At an OpenVMS load host: 23
- $ MCR NCP 26
- Downline Load Request Failure 27
- Is Defined Correctly 28
- Messages 29
- $ RUN SYS$SYSTEM:LATCP 33
- Local> SHOW MEMORY STATUS 36
- Low Pool Size: 52480 bytes 36
- Low Pool Used: 1940 bytes 36
- Verify Service Rating 39
- Telnet Resource Problems 43
- Verify Internet Host Name 45
- Telnet Client Hung 50
- SLIP/PPP Problems 55
- SLIP Connection Problems 57
- Verify SLIP Host Address 58
- PPP Connection Problems 65
- Failure Reasons 69
- AppleTalk Access Problems 71
- 3. AppleTalk Gateway Route 72
- Verify AppleTalk Is Enabled 73
- Verify AppleTalk State Is Up 73
- Verify Cache Size Is Correct 74
- Verify Attached Host Software 75
- Local> SHOW PORT 1 ATCP 76
- Local> SHOW PORT 1 76
- Performance Problems 77
- AppleTalk Gateway Route 78
- SNMP Access Problems 79
- Verify SNMP Enabled 82
- Verify Network Configuration 84
- MIB Information 85
- (NMS), do the following: 87
- Reported 89
- Access Problems 91
- TN3270 Connection Problems 92
- Verify TN3270 Keyboard Maps 94
- Telnet Negotiations Problems 97
- Procedure 101
- Authentication Protocol 102
- Overview 109
- Introduction 110
- Verify Internet Address 110
- Local> SHOW SERVER STATUS 111
- Console Port Problems 112
- Problems 113
- Port and Device Problems 114
- Solution 115
- Verify the Port Configuration 127
- Test the Printer Port 128
- LAT Printing Problems 131
- Verify the Print Queue 133
- Verify LAT Group Codes 136
- Telnet Printing Problems 138
- Connection 143
- Listener 145
- Echoes or Double Lines 148
- Modem Configuration Problems 149
- Dial-In User Procedure 151
- Access Server 154
- Not Respond 158
- Does Not Respond 161
- IPX Problems 165
- Network Access Software 167
- Management Guide 167
- Server Port 168
- Accounting Problems 171
- Problems with Accounting Log 172
- Verify Server Console Port 175
- Remote Login Problems 177
- Rlogin Connection Problems 178
- Verify Rlogin Server Username 183
- More Information 185
- Rlogin Client Hung 186
- Suspend IO Sequence 187
- Properly 188
- Some Applications 189
- Directed TFTP Problems 191
- Incorrect Filename 194
- Action: None 197
- >>> b eth:mneng2 197
- Messages 000 – 099 199
- Messages 200 – 299 201
- Corrupted solicit request 209
- Messages 300 – 399 211
- Messages 400 – 499 227
- (Chapter 3) 232
- Messages 500 – 599 243
- Local> INITIALIZE 244
- Messages 600 – 699 249
- Messages 700 – 799 257
- (Chapter 2) 269
- Messages 800 – 899 271
- (Chapter 272
- Messages 900 – 999 279
- Messages 1000 – 1099 291
- Messages 1100 – 1208 293
- Service Guidelines 299
- What To Do 300
- Digital Networks 302
Relacionado con productos y manuales para Redes Cabletron Systems Access Server 316
Redes Cabletron Systems HSIM-W6 Especificaciones
(60 paginas)
(60 paginas)
Redes Cabletron Systems CSX400 Especificaciones
(74 paginas)
(74 paginas)
Redes Cabletron Systems ELS10-26 Guía de usuario
(116 paginas)
(116 paginas)
Redes Cabletron Systems BRIM-E6 Especificaciones
(64 paginas)
(64 paginas)
Redes Cabletron Systems E2100 Manual de usuario
(12 paginas)
(12 paginas)
Redes Cabletron Systems BRIM-WT1 Manual de usuario
(35 paginas)
(35 paginas)
Redes Cabletron Systems 9T101-04 Guía de usuario
(28 paginas)
(28 paginas)
Redes Cabletron Systems CSX1200 Especificaciones
(106 paginas)
(106 paginas)
Redes Cabletron Systems SEHI100TX-22 Guía de usuario
(88 paginas)
(88 paginas)
Redes Cabletron Systems EFDMIM Guía de usuario
(36 paginas)
(36 paginas)
Redes Cabletron Systems 9F106-01 Especificaciones
(74 paginas)
(74 paginas)
Redes Cabletron Systems CSX400-DC Manual de usuario
(36 paginas)
(36 paginas)
Redes Cabletron Systems W85 Guía de usuario
(60 paginas)
(60 paginas)
Redes Cabletron Systems CBUPRI/E1 Especificaciones
(67 paginas)
(67 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.030 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales