Cabletron Systems MicroMMAC-44T Guía de usuario descargar pdf (Pagina 39)

INSTALLATION

3-4

Figure 3-4. Wall-Mounting the MicroMMAC-T

2. Select a wall location within seven feet of a power outlet for the

MicroMMAC-T.

WARNING: When drilling pilot holes, any electrical wiring inside the

wall may present a potential SHOCK HAZARD. Select a wall location

accordingly.

3. Position the MicroMMAC-T against the wall with the network port

facing down. Using a pencil, mark the wall location for the four pilot

holes.

4. Set the MicroMMAC-T aside and carefully drill four 1/4” pilot holes,

(one for each of the Molly screw anchors) and insert the four Molly

screw anchors into the holes.

5. Place a screw in each anchor, and tighten until each anchor expands

ﬁrmly in the wall; then remove the screws completely.

6. Position the MicroMMAC-T on the wall over the anchors and reinstall

the four screws to attach the MicroMMAC-T to the wall, as shown in

Figure 3-4. Tighten the four screws.

Molly Screws

Wall Mounting Bracket

Molly Screw

Anchors

Bracket Screws

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 104 105

Sin comentarios

Cabletron Systems MicroMMAC-44T Guía de usuario Pagina 39