Cabletron Systems MicroMMAC-44T Guía de usuario descargar pdf (Pagina 36)

3-1

CHAPTER 3

INSTALLATION

This chapter outlines MicroMMAC-T installation and network connection

procedures. Be sure that the network meets the guidelines and

requirements outlined in Chapter 2, Requirements/Speciﬁcations, before

installing the MicroMMAC-T.

3.1 UNPACKING THE MicroMMAC-T

Unpack the module carefully. Preserve and save all packaging materials

for possible storage or transport of the MicroMMAC-T.

Thoroughly inspect the MicroMMAC-T immediately. If there are any

signs of damage to the module, contact Cabletron Systems Technical

Support immediately.

3.2 ATTACHING THE STRAIN RELIEF BRACKET

Attach the strain relief bracket to the front of the MicroMMAC-T as

described:

1. From the MicroMMAC-T installation kit, locate the strain relief

bracket (shown in Figure 3-1) and four 8-32 x 3/8” screws.

CAUTION: Use of longer screws may cause damage to the unit or

electrical shock.

2. Attach the strain relief bracket to the bottom of the MicroMMAC-T as

shown in Figure 3-1.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 104 105

Sin comentarios

Cabletron Systems MicroMMAC-44T Guía de usuario Pagina 36