Cabletron Systems AirConnect 3Com Manual de usuario descargar pdf (Pagina 48)

48 CHAPTER 4: CONFIGURING THE ACCESS POINT USING A WEB BROWSER

System Parameters The AP has conﬁguration options to operate the unit, including security access

and interface control. Some parameters do not require modiﬁcation. To conﬁgure

the system parameters, follow the procedure below.

1 Select Conﬁguration-->System

The System Setup page displays

2 Type the AP’s name in the Unit Name text box.

3 Enter the appropriate value for Channel.

The table below lists the direct-sequence channel settings for the operating

countries.

4 Check Enabled or Disabled for Mobile IP.

5 Type a security key in the Mobile-Home MD5 Key text box. This security word key

is used for Mobile-Home registration and authentication.

6 Select the status of the Ethernet Timeout and enter the number of seconds

between 30 and 255.

This feature disables radio interface if no activity is detected on the Ethernet line

after the seconds indicated. The AP disassociates wireless clients and prevents

further associations with itself until it detects Ethernet activity.

If the Ethernet Timeout is disabled when the Ethernet connection is broken, the

AP clears the wireless client table and disables the RF interface until the Ethernet

connection is restored.

If the Ethernet Timeout is enabled when the Ethernet connection is broken

, the AP

sets the time-out value to zero (0) and attempts to associate with another WLAP in

the network.

7 Enter a value in seconds for Agent AD Interval. This speciﬁes the interval in

seconds between the mobility agent advertisement transmission. The default is 0.

8 Enable or disable interfaces on the AP.

Frequency No. of Channels Country

2412 11 Standard

2412 13 Europe

2457 2 Spain

2457 4 France

2484 14 Japan

Interface Description Default Condition

AP-AP State Xchg Specifies AP-to-AP communication exchanged.

If disabled, prevents AP Auto Configure and AP

load leveling function from operating.

Enabled

WNMP Functions Specifies whether the AP can perform WNMP

functions.

Enabled

Ethernet Interface Enables or disables wired Ethernet. On

RF Interface Enables or disables radio. On

Default Interface Specifies the default interface (Ethernet or PPP)

that the AP forwards a frame to if the AP

cannot find the address in its forwarding

database.

Ethernet

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 92 93

Comentarios a estos manuales

Sin comentarios

Cabletron Systems AirConnect 3Com Manual de usuario Pagina 48

Comentarios a estos manuales

Relacionado con productos y manuales para Puntos de acceso wlan Cabletron Systems AirConnect 3Com