Cabletron Systems T2015 Especificaciones descargar pdf (Pagina 115)

7-18

Alignment & Adjustments

Samsung Electronics

Service Manual

7.7 How to use EDC (Engine Diagnostic Control) Mode

7.7.1 EDC Establishment

EDC Mode is feature that allows the engineer to check the condition of the print engine. It can check the operating condi-

tion of the motors, sensors, solenoids and clutches, measure the High Voltage from the HVPS and check the operation of

the fuser and LSU.

7.7.1.1 How to enter the EDC Mode

a) Turn on the printer while pressing the "Enter" key. Hold the key until 'Select Test mode' appears in the display.

b) Press the direction key until "<EDC Test>" is displayed.

c) Press the "Enter" key.

d) <Enter Access Key> appears in the display. Press the cancel key twice.

Note. There are a number of other test modes. Only EDC Test and Panel Tests should be used by service engineers, all

other functions are for factory use only.

7.7.1.1 Functions of the keys on the Panel and how to use them.

Key Function Description

On Line Not used

Cancel Not used

Menu Menu Display Top Menu of EDC Mode

Left/Right Arrow Find Menu Move Menu

Confirm Run/Select Run run the Function / Select Menu

Upper Menu Stop/Move Stop Stop the selected Function or go to Upper Menu.

7.7.1.2 LCD Function and Directions

Upper Line : Upper Line messages mainly show the current test menu or sub-menu.

[Main Menu] or [Function] is displayed.

Lower Line : Lower Line messages mainly the current test and status.

Buttorns

Status Map Display : dispaly the printer

status and job in progress.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 227 228

Sin comentarios

Cabletron Systems T2015 Especificaciones Pagina 115