Cabletron Systems EPIM F3 Especificaciones descargar pdf (Pagina 12)

Software Conventions 1-5

Introduction

Device Name

Displays the user-deﬁned name of the device. The device name can be changed

via the System Group window; see the Generic SNMP Management Module

Guide for Windows for details.

IP Address

The Internet Protocol address assigned to the 9E312 or 9E423 Module; this ﬁeld

will display the IP address you have used to create the 9E312 or 9E423 Module in

the MMAC-Plus Chassis Setup window or to create its icon via SPECTRUM

Element Manager. IP addresses are assigned via Local Management.

Location

Displays the user-deﬁned location of the device. The location is entered through

the System Group window; see the Generic SNMP Guide for details.

MAC Address

Displays the manufacturer-set MAC address of the interface through which

SPECTRUM Element Manager is communicating with the 9E312 or 9E423

Module. MAC addresses are factory-set and cannot be altered.

Up Time

Displays the amount of time, in an X days hh:mm:ss format, that the 9E312 or

9E423 has been running since the last start-up.

Informational ﬁelds describing the ports being modeled are also displayed in

most windows:

Port Number

Displays the number of the monitored port.

Using Buttons and Menus

This button, that appears at the bottom of most windows, lets you exit a window

and terminate any unsaved changes you have made (if applicable).

Use these three buttons to save changes in a window and set them at the managed

device (if applicable). You may also have to use the Cancel button to close a

window after you have made changes and set them.

This button brings up a Help text box with information speciﬁc to the current

window. For more information concerning Help buttons, see Getting Help, later

in this chapter.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 66 67

Sin comentarios

Cabletron Systems EPIM F3 Especificaciones Pagina 12